P 11/ 14
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -5. Switch Block
[3] -6. Switch
DISASSEMBLING
After removing Switch lever (Refer to
Fig. 11
), separate Switch block from Motor housing as drawn in
Fig. 13
.
After removing Switch lever (Refer to
Fig. 11
), remove Switch from Switch block as drawn in
Fig. 14
.
Fig. 13
Insert Slotted screwdriver into the gap between Switch
block and Motor housing, remove Switch block from
Motor housing by twisting the screwdriver.
Fig. 14
Fig. 15
Switch block
Controller
DISASSEMBLING
[3] -7. Brush Holder
DISASSEMBLING
Insert Slotted screwdriver into the gap between Switch and Switch block.
While fitting the tip of the screwdriver to the side groove of Switch,
remove Switch by prying it off.
Remove 3x10 Tapping screw. Then, insert Slotted screwdrivers into the gap between Motor housing
and Brush holder’s plastic portion. And then, disassemble Brush holder by prying them off.
Brush holders can be disassembled as drawn in
Fig. 15
.
Brush holder
Slotted screwdriver
Switch
Slotted screwdrivers
Slotted screwdriver
