8 ENGLISH
Insert the drill bit into the tool. Turn the drill bit and push
it in until it engages.
After installing the drill bit, always make sure that the
drill bit is securely held in place by trying to pull it out.
1
►
1.
Drill bit
To remove the drill bit, pull the chuck cover down all the
way and pull the drill bit out.
1
2
►
1.
Drill bit
2.
Chuck cover
Depth gauge
The depth gauge is convenient for drilling holes of
uniform depth. Loosen the side grip and insert the depth
gauge into the hole on the side grip. Adjust the depth
gauge to the desired depth and tighten the side grip
firmly.
1
2
►
1.
Hole
2.
Depth gauge
NOTE:
Make sure that the depth gauge does not
touch the main body of the tool when attaching it.
Dust cup (optional accessory)
Use the dust cup to prevent dust from falling over the
tool and on yourself when performing overhead drilling
operations. Attach the dust cup to the bit as shown in
the figure. The size of bits which the dust cup can be
attached to is as follows.
Model
Bit diameter
Dust cup 5
6 mm - 14.5 mm
Dust cup 9
12 mm - 16 mm
1
►
1.
Dust cup
Dust cup set
Optional accessory
NOTICE:
Do not use the dust cup set when drill
-
ing in metal or similar.
It may damage the dust cup
set due to the heat produced by small metal dust or
similar. Do not install or remove the dust cup set with
the drill bit installed in the tool. It may damage the
dust cup set and cause dust leak.
NOTE:
The standard side grip cannot be used
with the dust cup set being installed on the tool.
When the dust cup set is installed on the tool, remove
the grip from the standard side grip, and then attach it
to the optional grip base set.
Before installing the dust cup set, remove the bit from
the tool if installed.
Install the spacer so that the grooves on the spacer fit in
the protrusions on the tool barrel while widening it. Be
careful for the spring not to come off from the slit of spacer.
1
2
►
1.
Spacer
2.
Spring
