[3] DISASSEMBLY/ASSEMBLY
[3]-6. Swash bearing 10, Inner housing section
ASSEMBLING
Fig. 25
(3) Refer to
Fig. 25
.
Note
: Apply grease according to
Fig. 1 of page 4.
1. Tighten Swash bearing section with
two M4x16 Hex socket head bolts.
Note
: Apply ThreeBond 1342 or
Loctite 243 to the thread of
the bolts.
2. Mount Striker into Piston cylinder.
Note
: Try inserting Striker into Piston cylinder
and pulling it out in advance as drawn in
Fig. 18 of page 14
.
Flat washer 30
Tool holder section
O ring 17.5
Striker
Pliers
3. Mount two Clutch cams to
Cam shaft.
Note
: They have same shape.
However, one must be
engaged with Spur gear 10.
The other must be engaged
with the gear teeth of
cam shaft.
4. Make sure that Flat washer 30 is put on Inner housing
complete in advance.
And then set Tool holder section in place, after that,
Assemble Flat washer 7 to Cam shaft and secure it by
fitting Stop ring EXT U-6 into the groove of Cam shaft.
6. Insert Pin 6 into Inner housing complete
through Counter weight and Weight holder.
7. Mount Plate as a stopper for Pin 6, and tighten it with
two M4x12 Hex socket head bolts.
Note
: Apply
Loctite 243 or ThreeBond 1342
to the threads of the bolts in advance.
Spur gear 10
Gear teeth of
Cam shaft
Clutch cam
(2 pcs.)
Flat washer 7
Stop ring EXT U-6
Weight holder
hole
Pin
Counter weight
Pin 6
Pin 6
Plate
5. Assemble Counter weight and two Weight holders
so that there holes align the projection of Swash
bearing/ the holes of Inner housing complete.
Spur gear 10
Swash bearing 10
P 17/ 25
R
epair
M4x16 Hex
socket head
bolt (2 pcs.)
