[3] DISASSEMBLY/ASSEMBLY
[3]-4. Torque limiter section
DISASSEMBLING
Compression
spring 4
1. Tap Tool holder complete with a plastic hammer
while holding Gear housing complete by hand.
2. Disassemble Change plate section.
It consists of Change plate A, Change plate B
and Compression spring 5.
3. Stop ring U-6 and Flat washer 7 interferes with pulling out Tool holder section.
So, disassemble Stop ring U-6 with long nose pliers and then remove Flat washer 7.
Lock plate
Note
: These parts are easy to fall out of
Gear housing complete, and therefore,
be careful not to lose them.
Note
: Change plate section can be
easily removed by hand
because it is just fit to the slit
of Clutch cam.
R
epair
(1) Disassemble Bit holder section as drawn in
Fig. 2 of page 5
.
(2) Disassemble Change lever section as drawn in
Fig. 4 of page 6
.
(3) Disconnecting Carbon brush from Commutator of Armature, pull off Armature from Gear housing complete as
drawn in
Fig. 6 of page 7 and Fig. 7 of page 8
.
(4) Tap Tool holder with a plastic hammer. Inner housing section comes out from Gear housing complete.
Then, remove Tool holder section from Inner housing complete. (
Fig. 9
)
Fig. 9
Change plate section
Stop ring U-6
4. Tool holder section
can be pulled out.
Flat washer 7
Long nose pliers
Flat washer 30
on Inner
housing
complete side
Tool holder
section
P 9/ 25
