P
4
/ 2
3
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Chuck Section
R
epair
DISASSEMBLY
4x14 Tapping
Screw (2 pcs.)
Handle section
1) Disassemble Handle section.
(Fig. 4)
Hold the machine upright and disassemble Chuck section in the order of
Figs. 5
to 11
.
Connector
Controller
Motor
housing
Tool holder cap
Holding the machine upright with
1R350 as illustrated below, remove
Tool holder cap.
1R350
1. Separate Handle section from Motor housing
by unscrewing 5x25 Tapping screws.
2. Pull off Connector from Controller.
3. After removing 4x14 tapping screws, disassemble
Controller from Motor housing.
Ring spring 25
While pulling down Chuck cover, remove Ring spring 25
from the Tool holder using 1R003 with 1R212.
1R003 with 1R212
Chuck cover
1R003
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Tool holder
Tool holder
Ring 28
Ring 28
After removing Ring spring 25, disassemble
the following parts in order from Tool holder.
1. Ring 28
2. Chuck cover
3. Spacer
Ring spring 25
Chuck cover
Spacer
Chuck ring
5x25 Tapping
screw (6 pcs.)
