R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -2. Reciprocating Mechanism
DISASSEMBLING
2. Turn DC motor shaft to move
Collared sleeve 4 up to the top
position of Slider’s elliptical hole.
4. Remove Slider section from the
Collared sleeve 4.
5 . Remove Collared sleeve 4.
7. Now, remove Gear
complete and Pin 3.
8. Remove Balance plate and Push plate
from Bearing case complete.
9. Remove DC motor from Bearing
case complete with 1R269.
Slider
Collared
sleeve 4
Collared
sleeve 4
Housing L
3. A space for removing
Slider from Collared
sleeve 4 is secured.
Slider
Collared sleeve 4
Slider section
Leaf spring
Gear complete
Push plate
Dust seal
Balance plate
Bearing case
complete
Pin 3
Retaining ring S-6
6 . Remove Retaining
ring S-6 with 1R291.
Note;
Retaining ring S-6 is deformed
in this step.
Do not re-use it.
Bearing case
complete
DC motor
(1) Separate Housing R from Housing L (
Fig. 2
).
(2) Now, Reciprocating mechanism can be disassembled (
Fig. 4
).
Fig. 4
Collared sleeve 4
1. Remove Leaf spring.
P
4
/ 1
1
