6
ENGLISH
Explanation of general view
SPECIFICATIONS
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
END201-7
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
.... Read instruction manual.
.............. DOUBLE INSULATION
ENE001-1
Intended use
The tool is intended for planing wood.
ENF002-2
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
GEA012-2
General power tool safety
warnings
WARNING: Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool.
Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and
instructions for future reference.
The term “power tool” in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Work area safety
1.
Keep work area clean and well lit.
Cluttered or dark
areas invite accidents.
2.
Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust.
Power tools
create sparks which may ignite the dust or fumes.
1.
Pointer
2.
Knob
3.
Lock button or Lock-off button
4.
Switch trigger
5.
Planer blade
6.
Rear base
7.
Foot
8.
Socket wrench
9.
Bolt
10. Drum
11. Drum cover
12. Adjusting plate
13. Inside edge of gauge plate
14. Blade edge
15. Screw
16. Heel
17. Back side of gauge base
18. Gauge plate
19. Gauge base
20. Pan head screw
21. Planer blade locating lugs
22. Heel of adjusting plate
23. Set plate
24. Inside flank of gauge plate
25. Mini planer blade
26. Groove
27. Hex. flange head bolt
28. Dust bag
29. Nozzle
30. Fastener
31. Elbow
32. Start
33. End
34. Cutting line
35. Edge fence (Accessory)
36. Sharpening holder
37. Wing nut
38. Blade (A)
39. Blade (B)
40. Side (D)
41. Side (C)
42. Limit mark
43. Chip cover
44. Screwdriver
45. Brush holder cap
Model
KP0800
Planing width
82 mm
Planing depth
2.5 mm
Shiplapping depth
9 mm
No load speed (min
-1
)
17,000
Overall length
285 mm
Net weight
2.7 kg
Safety class
/II
