9
ENGLISH
Lubricating moving parts
NOTICE:
Follow the instruction of the fre-
quency and amount of grease supplied.
Otherwise
insufficient lubrication may damage moving parts.
Gear case:
CAUTION:
Do not apply grease when the
gear case is hot.
Hot gear case can cause burn
injury.
Fill approx. 30 ml of grease (Makita grease SG No.0)
through the grease port evenly every 25 hours of
operation.
With the supplied hexalobular wrench, remove the bolt
near the lubrication marking on the gear case. Loosen
the bolt on the other side so that the air in the gear case
can be released when applying the grease.
After applying the grease, be sure to tighten the bolts.
1
2
►
1.
Bolt
2.
Gear case
Drive axle:
Apply grease (Makita grease SG No.0) every 25 hours
of operation.
NOTE:
Genuine Makita grease may be purchased
from your local Makita dealer.
Storage
WARNING:
Follow the warnings and precau-
tions in the chapter “SAFETY WARNINGS” and
the instruction manual of the power unit.
When storing the attachment separated from the power
unit, put the cap onto the end of the shaft.
Interval of inspection and maintenance
Operating hour
Before
Operation
Daily (10h)
25h
Whole unit
Visually inspect for damaged parts
-
-
All fixing screws and nuts
Tighten
-
-
Rotor blades and protector
Clean and visually inspect for dam
-
aged parts
-
-
Gear case
Supply grease
-
-
Drive axle
Supply grease
-
-
Power unit
Refer to the instruction manual of the power unit
