7
Misfiring may cause personal injuries and property
damage.
Remove the battery cartridge.
Press the locking lever and slide the magazine.
Take out pin nails from the magazine slit.
Nose adapter
CAUTION:
•
Always make sure that your fingers are not placed
on the trigger or the lever and the battery cartridge
is removed before installing the nose adapter.
1
2
3
4
007736
When firing pin nails on the material to be fastened with
easily-marred surfaces, use the nose adapter. To install
the nose adapter, place it over the driver guide cover so
that the protrusion inside the nose adapter fits to the slit
in the driver guide cover.
When not in use, store the nose adapter in the holder at
the back end of the magazine to keep it from being lost.
Hook
CAUTION:
•
Always make sure that your fingers are not placed
on the trigger or the lever and the battery cartridge
is removed before using the hook.
007737
CAUTION:
•
Do not hang the hook from the waist belt. Dropping
the pin nailer, which is caused by the hook
accidentally coming out of place, may cause
misfiring and personal injuries.
1
2
3
011940
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw. To
remove, loosen the screw and then take it out.
Hex wrench storage
1
011941
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
OPERATION
Driving pin nails
WARNING:
•
Before pulling the trigger, always make sure that
the opening that pin-nails are fired contacts
material to be fastened. Just pulling the trigger fires
pin nails. Misfiring may cause personal injuries.
1
2
011942
Place flat the opening of the tool that pin-nails are fired
on the material to be fastened and hold the tool firmly
against the material. Then pull the lever and then pull the
trigger fully to drive the pin nail. The grip is shaped so
that the tool head can be held down securely with index
finger and thumb. After driving a pin-nail, be sure to
release the trigger fully.
1. Trigger
2. Material to be
fastened
1. Hex wrench
1. Groove
2. Hook
3. Screw
1. Driver guide
cover
2. Protrusion
3. Nose adapter
4. Holder
