Makita M6600, Instruction Manual

6 ENGLISH

Installing the mixing blade

► 

Fig.5

To mount the mixing blade, install it with the " UP " mark 

on it facing the tool (directing inside).

Install the mixing blade on the top of shaft and secure it 

with hex bolt.

► 

Fig.6:

1.

 Mixing blade 

2.

 Shaft 

3.

 Hex bolt

In case of mixing blade 150 (accessory), screw it 

directly on the top of shaft as it is threaded.

Installing top grip (auxiliary handle)

► 

Fig.7

Screw the top grip on the tool securely.

Installing back grip (country specific)

► 

Fig.8:

1.

 Leaf spring 

2.

 Rear handle 

3.

 Boss

Pull off the cap from the tool housing. Insert the leaf 

springs into the groove of the handle part that has the 

bosses. Then attach them to the bottom of the tool 

housing.

► 

Fig.9:

1.

 Rear handle 

2.

 Screw

Attach both of the handle parts and tighten them with 

the screws securely.

OPERATION

CAUTION:

Do not mix flammable materials or 

operate the tool around flammable materials such 

as paint with thinner used as solvent.

 Failure to do 

so may cause an injury.

CAUTION:

When you mix the material while 

the mixing blade floating out of the material, be 

careful not to splash the material.

► 

Fig.10

1.

  Always use the top or back grip (auxiliary handle) 

and firmly hold the tool by top or back grip and switch 

handle during operations.

2.

  Place the mixing blade under material fully and 

turn on the tool after making sure work site safety.

3.

  Move the mixing blade up and down during the 

mixing operation so that whole part of material can be 

mixed.

4.

  When finishing mixing, turn off the tool, make sure 

that the mixing blade has come to a complete stop, and 

then pull it out of the mixing container.

MAINTENANCE

CAUTION:

Always be sure that the tool is 

switched off and unplugged before attempting to 

perform inspection or maintenance.

NOTICE:

Never use gasoline, benzine, thinner, 

alcohol or the like. Discoloration, deformation or 

cracks may result.

Replacing carbon brushes

► 

Fig.11:

1.

 Limit mark

Check the carbon brushes regularly.

Replace them when they wear down to the limit mark. 

Keep the carbon brushes clean and free to slip in the 

holders. Both carbon brushes should be replaced at the 

same time. Use only identical carbon brushes.

1.

  Use a screwdriver to remove the brush holder 

caps.

2.

  Take out the worn carbon brushes, insert the new 

ones and secure the brush holder caps.

► 

Fig.12:

1.

 Brush holder cap

To maintain product SAFETY and RELIABILITY, 

repairs, any other maintenance or adjustment should 

be performed by Makita Authorized or Factory Service 

Centers, always using Makita replacement parts.

OPTIONAL 

ACCESSORIES

CAUTION:

These accessories or attachments 

are recommended for use with your Makita tool 

specified in this manual.

 The use of any other 

accessories or attachments might present a risk of 

injury to persons. Only use accessory or attachment 

for its stated purpose.

If you need any assistance for more details regard-

ing these accessories, ask your local Makita Service 

Center.
• 

Mixing blade

Type

Maximum diameter

Twin blade 

possible

Mixing blade 130

130 mm

-

Mixing blade 150

150 mm

-

Mixing blade 165

165 mm

-

• Shaft

NOTE:

 Some items in the list may be included in the 

tool package as standard accessories. They may 

differ from country to country.