6 ENGLISH
10.
Keep hands away from moving parts.
11.
Do not leave the tool running. Operate the tool
only when hand-held.
12.
Do not point the tool at any one in the area
when operating. The bit could fly out and
injure someone seriously.
13.
Do not touch the bit or parts close to the bit
immediately after operation; they may be
extremely hot and could burn your skin.
14.
Some material contains chemicals which may
be toxic. Take caution to prevent dust inhala
-
tion and skin contact. Follow material supplier
safety data.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or famil
-
iarity with product (gained from repeated
use) replace strict adherence to safety
rules for the subject product. MISUSE or
failure to follow the safety rules stated in
this instruction manual may cause serious
personal injury.
FUNCTIONAL
DESCRIPTION
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Switch action
►
Fig.1:
1.
Switch trigger
2.
Lock button
CAUTION:
•
Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the “OFF” position when released.
•
Switch can be locked in “ON” position for ease
of operator comfort during extended use. Apply
caution when locking tool in “ON” position and
maintain firm grasp on tool.
To start the tool, simply pull the switch trigger. Tool
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop. For contin-
uous operation, pull the switch trigger, push in the lock
button and then release the switch trigger. To stop the
tool from the locked position, pull the switch trigger fully,
then release it.
Reversing switch action
►
Fig.2:
1.
Reversing switch lever
CAUTION:
•
Always check the direction of rotation before
operation.
•
Use the reversing switch only after the tool
comes to a complete stop. Changing the direc-
tion of rotation before the tool stops may dam-
age the tool.
•
If the switch trigger can not be depressed, check
to see that the reversing switch is fully set to
position
(A side) or
(B side).
This tool has a reversing switch to change the direc
-
tion of rotation. Move the reversing switch lever
to the
position (A side) for clockwise rotation or
the position (B side) for counterclockwise rotation.
Selecting the action mode
►
Fig.3:
1.
Action mode changing knob
2.
Rotation
only
3.
Rotation with hammering
This tool employs an action mode changing knob.
Select one of the two modes suitable for your work
needs by using this knob.
For rotation only, turn the knob so that the arrow on the
knob points toward the
symbol on the tool body.
For rotation with hammering, turn the knob so that the
arrow on the knob points toward the
symbol on the
tool body.
CAUTION:
•
Always set the knob fully to your desired mode
symbol. If you operate the tool with the knob
positioned halfway between the mode symbols,
the tool may be damaged.
•
Use the knob after the tool comes to a complete
stop.
Torque limiter
The torque limiter will actuate when a certain torque
level is reached. The motor will disengage from the out
-
put shaft. When this happens, the bit will stop turning.
CAUTION:
•
As soon as the torque limiter actuates, switch
off the tool immediately. This will help prevent
premature wear of the tool.
•
Bits such as hole saw, which tend to pinch or
catch easily in the hole, are not appropriate for
this tool. This is because they will cause the
torque limiter to actuate too frequently.
