P
4
/
8
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -2. Anvil, Bit Holder Section
DISASSEMBLING
Steel ball 3.5 (2psc.)
Compression
spring 13
Raise this side (opposite to the expanded side) with index finger
when removing Ring spring 11.
Ring spring 11
Expand the end gap of
Ring spring 11 with 1R291.
Sleeve
1R291
Flat washer 12
Sleeve
Anvil
1R232
Flat washer 12, Compression spring 13 and
Sleeve can now be removed from Anvil.
Anvil and Nylon washer 14 can now be removed from
Hammer case complete.
Note
: Be careful not to lose Steel balls 3.5.
Fig. 5
Fig. 6
Anvil
Nylon washer 19
Hammer case complete
Anvil
Ring spring 11
(1) Remove Hammer case and Hammer section from Housing set as per the
left
drawing in
Fig. 2
.
(2) Disassemble Bit holder section and Anvil as drawn in
Figs. 5
and
6
.
Use 1R232 to hold Anvil firmly.
Press the top of Sleeve with
thumb to prevent Compression
spring 13 from popping out
and away.
Assemble Anvil and Bit holder section by reversing the disassembly procedure. (
Figs. 6
and
5
)
ASSEMBLING
