24
Reassemble the blade (2) with the code and markings fac-
ing the ground, following the order indicated in the illustra-
tion.
Tighten the central screw (1) using a torque wrench set to
35-40 Nm.
In power-driven models (excluding models with
speed gear), adjust the tension of the belt with the nut (1)
to get the right measurement (6 mm).
The control cable must be adjusted if the difference
in speed between position «2» and position «
» is minimal
or nil.
NOTE - The adjustment must be made with the engine
switched off.
Gradually turn register (2) anticlockwise (so as to cause it
to extend) until control lever (1) has difficulty in reaching
position «
»; at this point turn the register clockwise by
about half a turn, to obtain optimal adjustment of the for-
ward speed, together with correct engagement of the four
speeds using control lever (1).
To clean inside the machine, use the hosepipe con-
nector (1) provided.
Always stand behind the machine's handle when cleaning.
Environmental protection should be a priority of consider-
able importance when using the machine, for the benefit of
both social coexistence and the environment in which we
live.
– Try not to cause any disturbance to the surrounding area.
– Scrupulously comply with local regulations and provi-
sions for the disposal of waste materials after cutting.
– Scrupulously comply with local regulations and provi-
sions for the disposal of pakagings, oils, petrol, batteries,
filters, damaged parts or any elements which have a
strong impact on the environment; this waste must not
be disposed of as normal waste, it must be separated
and taken to specified waste disposal centres where the
material will be recycled.
– At the time of decommissioning, do not pollute the envi-
ronment with the machine, hand it over to a disposal
centre, in accordance with the local laws in force.
Should you have any doubts or problems, do not hesitate
to contact the nearest Service Centre or your Sales outlet.
5. ENVIRONMENTAL PROTECTION
4.4
4.3
4.2
Summary of Contents for PLM4815
