8 ENGLISH
1
2
3
4
►
1.
Shaft lock
2.
Hex wrench
3.
Tighten
4.
Loosen
1
2
3
4
5
►
1.
Hex bolt
2.
Outer flange
3.
Diamond wheel
4.
Inner flange
5.
Arrow
To remove the diamond wheel, press the shaft lock fully
so that the diamond wheel cannot revolve and use the
hex wrench to loosen the hex bolt counterclockwise.
Then remove the hex bolt, outer flange and diamond
wheel.
To install the diamond wheel, follow the removal pro-
cedure in reverse. Make sure the diamond wheel is
installed so that the arrow on the wheel points in the
same direction as the arrow on the diamond wheel
case.
BE SURE TO TIGHTEN THE HEX BOLT SECURELY.
1
2
3
4
5
►
1.
Hex bolt
2.
Outer flange
3.
Diamond wheel
4.
Inner flange
5.
Protrusion (bigger side)
NOTE:
If an inner flange is removed by chance,
install the inner flange so that its protrusion (bigger
side) faces inside as shown in the figure.
Hex wrench storage
1
►
1.
Hex wrench
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Installing water supply
Loosen the screw A.
Slide the tank holder all the way over the motor housing so
that the notch of the band (part of the tank holder) is posi-
tioned just below the screw head of the tool as illustrated.
Then tighten the screw A.
1
2
3
4
5
►
1.
Screw A
2.
Tank holder
3.
Motor housing
4.
Notch
of the band (part of the tank holder)
5.
Screw head
of the tool
Attach the tank on the tank holder so that the tank
holder fits between the step and dots. Connect the cap
on the tube end to the mouth of the tank. Turn the tank
clockwise. Then tighten the screw B.
2
3
1
►
1.
Tank
2.
Tube
3.
Screw B
