Makita TD111DSAJ, Instruction Manual

8 ENGLISH

ASSEMBLY

CAUTION:

Always be sure that the tool is 

switched off and the battery cartridge is removed 

before carrying out any work on the tool.

Installing or removing driver bit/

socket bit

Optional accessory

Use only driver bit/socket bit that has inserting portion 

shown in the figure. Do not use any other driver bit/

socket bit.

For tool with shallow driver bit hole

A=12mm

B=9mm

Use only these type of driver 

bit. Follow the procedure 

1. (Note) Bit-piece is not 

necessary.

For tool with deep driver bit hole

A=17mm

B=14mm

To install these types of driver 

bits, follow the procedure 1.

A=12mm

B=9mm

To install these types of driver 

bits, follow the procedure 2. 

(Note) Bit-piece is necessary 

for installing the bit.

1.  To install the driver bit, pull the sleeve in the direc

-

tion of the arrow and insert the driver bit into the 

sleeve as far as it will go. 

Then release the sleeve to secure the driver bit.

1

2

►    

1.

 Driver bit 

2.

 Sleeve

2.  To install the driver bit, pull the sleeve in the direc

-

tion of the arrow and insert the bit-piece and driver 

bit into the sleeve as far as it will go. The bit-piece 

should be inserted into the sleeve with its pointed 

end facing in. Then release the sleeve to secure 

the driver bit.

1

3

2

►    

1.

 Driver bit 

2.

 Bit-piece 

3.

 Sleeve

To remove the driver bit, pull the sleeve in the direction 

of the arrow and pull the driver bit out.

NOTE:

 If the driver bit is not inserted deep enough 

into the sleeve, the sleeve will not return to its original 

position and the driver bit will not be secured. In this 

case, try re-inserting the bit according to the instruc-

tions above.

NOTE:

 After inserting the driver bit, make sure that it 

is firmly secured. If it comes out, do not use it.

Installing hook

3

2

1

►    

1.

 Groove 

2.

 Hook 

3.

 Screw

The hook is convenient for temporarily hanging the tool. 

This can be installed on either side of the tool. To install 

the hook, insert it into a groove in the tool housing on 

either side and then secure it with a screw. To remove, 

loosen the screw and then take it out.