11
3
4
E
To guarantee a troublefree operation of the oil pump the oil
guide groove (E/3) as well as the oil inlet bore in the guide bar
(E/4) must be cleaned in regular intervals.
H
Holding the chain saw
Always grip each handle with the thumb and fingers
encircling the handle as shown in Fig. H.
Use this grip thumb
below handle!
Switching on the motor
5
6
F
7
G
NOTE:
When the chain brake is actuated the power supply to the
motor will be cut off.
If the saw does not start when the ON/OFF switch (F/6) is
actuated, it will be necessary to release the chain brake.
-
Pull the hand guard (G/7) firmly in the direction of the
arrow until you feel it catch.
-
Plug in the saw.
-
When switching on the electric chain saw always hold
it with both hands.
-
Take the back handle with the right hand and the tubular
handle with the left hand. Hold the handles tightly with your
thumbs facing your fingers. The bar and chain must not be
in contact with any object.
-
First depress the locking button (F/5) and then the power
switch (F/6). Then release the locking button (F/5).
-
Attention: The chain starts running immediately. Keep
the power switch depressed as long as the motor is to run.
CAUTION:
Never lock the power switch in the ON position.
Switching off the motor:
-
Release the power switch (F/6).
