10 ENGLISH
CAUTION:
The O ring may come out of the
sanding base while replacing the pad. Set the O
ring back in the circular grooves around the cen-
ter of the base before installing the optional pad.
1
2
3
Fig.13
►
1.
O ring
2.
Sanding base
3.
Circular grooves
Installing and removing dust bag
Attach the dust bag over the tapered dust spout at the
back end of the motor housing. Put the dust inlet of the
bag onto the dust spout as far as it will go to avoid it
from coming off during operation.
1
2
3
Fig.14
►
1.
Dust spout
2.
Dust inlet
3.
Dust bag
NOTE:
Make sure to attach the dust bag with its
zipper slider facing downwards.
NOTE:
To ensure optimal dust collecting, empty the
dust bag when it becomes filled to approximately half
of its capacity.
Remove the dust bag from the tool and pull the fas-
tener out. Then gently shake or tap the dust bag to
empty.
Installing and removing dust box
Optional accessory
Attach the dust box over the tapered dust spout at the
back end of the motor housing. Put the dust nozzle onto
the dust spout as far as it will go to avoid it from coming
off during operation.
1
2
3
Fig.15
►
1.
Dust spout
2.
Dust nozzle
3.
Dust box
NOTE:
To ensure optimal dust collecting, empty the
dust box when it becomes filled to approximately half
of its capacity.
1. Remove the dust box from the tool.
2. Detach the dust nozzle from the box while
pressing and holding the locking latches on both
sides of the box.
3. Gently shake or tap the dust box to empty.
Replacing filter
NOTICE:
Be aware to align the logos on all the
dust box, filter and dust nozzle in a consistent
orientation when reassembling components.
1.
Remove the dust box from the tool.
2.
Detach the dust nozzle from the box while press-
ing and holding the locking latches on both sides of the
box.
1
2
3
3
Fig.16
►
1.
Dust nozzle
2.
Dust box
3.
Locking latch
3.
Hold the inner top edge of the cardboard opening,
and pull it off downwards to disengage the outer top
edge of the cardboard opening from the upper hooking
tab on the lip of the dust box.
