8
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing the backing pad
3
1
2
►
1.
Hex wrench
2.
Bolt
3.
Backing pad
Put the backing pad on the shaft then turn the bolt
clockwise with a hex wrench.
CAUTION:
Make sure that the backing pad is
secured properly.
Loose attachment will run out of
balance and cause an excessive vibration which may
cause loss of control.
Installing side grip
Optional accessory
CAUTION:
Tighten the caps or side grip firmly.
Otherwise, the front cover may fall and cause an injury.
1
2
►
1.
Cap
2.
Side grip
Remove the cap and screw the side grip on the tool securely.
The side grip can be installed on either side of the tool.
Installing or removing pad
Optional accessory
CAUTION:
Only use hook-and-loop system
pads for polishing.
1
►
1.
Pad
To install the pad, �st remove all dirt and foreign matter from the
hook-and-loop system of the pad and the backing pad. Attach the
pad to the backing pad so that their edges are aligned.
To remove the pad from the backing pad, just pull up from its edge.
