Makita XPP01, Instruction Manual

13 ENGLISH

6.

  Continue to pull the switch trigger until the punch reaches 

the end of its stroke and returns to the starting position.
The punch rod will extend and push the punch through 

the workpiece.

NOTE:

To aid accurate and easy positioning of the punch, 

pull the switch trigger intermittently to jog the punch down 

to the workpiece. If the position is not satisfactory, open 

the return lever to retract the punch for another attempt. If 

the punch doesn’t return to its starting position with return 

lever open, pull the switch trigger to return the punch.

NOTE:

 If the punch doesn’t return after punching 

finishes, release the switch trigger to stop the motor 

and pull the switch trigger again.
If the punch doesn’t return even after performing above 

procedures, perform the procedures for stopping the oper-

ation before the completion of punching mentioned below.

Stopping the operation before the 

punching is finished

If you want to stop the operation before the punching is 

finished, perform the procedures below:

1.

  Turn the return lever counterclockwise until it hits the 

spring pin and then immediately back to its starting position.

Doing this releases the internal pressure of the tool. If 

the punch retracts from the workpiece under its own 

power, allow the punch to fully return. After that, turn the 

return lever back to its starting position. In this case, the 

following step is not necessary.

2.

Continue to pull the switch trigger until the punch 

returns to its starting position.

Using slide stopper for maximum depth

Optional accessory

CAUTION:

Before attaching or removing the 

slide stopper, ensure that the battery cartridge 

is removed to prevent accidental operation and 

personal injury.

Punching up to 40 mm (1-37/64″) depth from the edge of the 

workpiece can be done using the optional slide stopper.

1

2

►    

1.

 Bolt and washer 

2.

 Optional slide stopper

1.

Loosen the set bolt and nut to remove the die.

2.

Remove the bolt and washer fixing the slide stopper.

3.

  Remove the slide stopper by pulling it to the upper 

side of the C frame.

4.

Insert the optional slide stopper for maximum 

depth from the bottom side of the C frame.

5.

Fix the optional slide stopper with the bolt and 

washer removed in step 2.

6.

  Install the die with the set bolt and nut removed in step 1.

MAINTENANCE

CAUTION:

Always be sure that the tool is 

switched off and the battery cartridge is removed 

before attempting to perform inspection or 

maintenance.

NOTICE:

Never use gasoline, benzine, thinner, 

alcohol or the like. Discoloration, deformation or 

cracks may result.

To maintain product SAFETY and RELIABILITY, 

repairs, any other maintenance or adjustment should 

be performed by Makita Authorized or Factory Service 

Centers, always using Makita replacement parts.

Regular maintenance

Keep the air hole at the end of the C frame clear of dirt 

and obstructions. The air hole has to be open in order to 

control the hydraulic pressure.

1

►    

1.

 Air hole

Do not undo or remove the three screws as shown in 

the figure. Doing so will cause oil to leak from the tool.