8
sleeve as far as it will go. The bit-piece should be
inserted into the sleeve with its pointed end facing
in. Then release the sleeve to secure the bit.
1
2
3
004347
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
•
If the bit is not inserted deep enough into the sleeve,
the sleeve will not return to its original position and
the bit will not be secured. In this case, try
re-inserting the bit according to the instructions
above.
Hook (Accessory)
2
3
1
006251
CAUTION:
•
When installing the hook, tighten the screw firmly.
Failure to do so may cause the breakage of the tool
or personal injury.
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw. To
remove, loosen the screw and then take it out.
OPERATION
CAUTION:
•
Always insert the battery cartridge all the way until it
locks in place. If you can see the red part on the
upper side of the button, it is not locked completely.
Insert it fully until the red part cannot be seen. If not,
it may accidentally fall out of the tool, causing injury
to you or someone around you.
Impact driver operation
When driving wood screws or bolts. set the action mode
changing lever to the
mark. The adjusting ring can be
placed at any position.
Screwdriving
Hold the tool firmly and place the point of the driver bit in
the screw head. Apply forward pressure to the tool to the
extent that the bit will not slip off the screw and turn the
tool on to start operation.
014133
Tightening bolts
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between
fastening torque and fastening time is shown in the
figures.
12
0
1
00
80
60
40
2
0
S
tandard
bo
l
t
N
m
F
asten
i
ng
tor
q
ue
F
asten
i
ng
t
i
me
S
)
P
roper
fasten
i
ng
tor
q
ue
(ft
l
bs)
(
8
7)
(72)
(
58
)
(
43
)
(29)
(1
4
)
(
0
1
.0
2
.0
3.0
M1
4
(9
/
1
6"
)
M12(1
/
2
"
)
(M1
4
)
M1
0
(
3/8"
)
(M12)
M
8
(
5/
1
6"
)
(M1
0
)
(M
8
)
0
(9
/
1
6"
)
(1
/
2
"
)
(
3/8"
)
(
5/
1
6"
)
007317
1. Hook
2. Screw
3. Groove
1. Bit
2. Bit-piece
3. Sleeve
