Makita XRU09, Repair Manual

P 11/ 19

R

epair

Fig. 3-1-4

Fig. 3-1-5

Fig. 3-1-6

1. Remove six 4x18 Tapping screws and M5x18 

    Hex socket head bolt, and then remove Grip R.

Note

: When you want to remove Power supply cord unit (long) from Pipe complete, both the connector ends of 

          the power supply cord unit must be disconnected in advance. Therefore, do the following steps.   

          1. Disconnect the other connector of the power supply cord unit from the connector of Stator ass’y in 

              Motor housing complete.

          2. Loosen Strain relief in Motor housing complete, and then remove the clamped Power supply cord unit.

          3. Pull out the power supply cord unit toward Housing set side with care of the connector that is passed through 

              Pipe complete.

2. Remove Lock off lever together with 

    Torsion spring 9 by lifting them up.

3. Remove Switch lever together with 

    Torsion spring 10 by lifting them up.

Loosen M5x18 Hex socket head bolt, and then remove Spacer 24 and Hanger from Pipe complete.

4x18 Tapping screw (6 pcs.)

M5x18 Hex socket head bolt

Grip R

Torsion spring 9

Housing set side

Housing set side

To Motor housing complete

To Motor housing complete

Lock off lever

Switch lever

Torsion spring 10

Spacer 24

Hanger

M5x18 Hex socket head bolt