8
of the adjustment, tighten the knob securely.
1
014864
Install the end of the knob into the center of the circle to
be cut, and proceed to cut in a clockwise direction.
Vacuum cover (optional accessory)
To perform cleaner operations, use the vacuum cover
and connect the tool to Makita vacuum cleaner or dust
collector.
1
2
014851
Loosen the thumb screw and remove the shoe. Attach
the vacuum cover, and fasten it securely with the thumb
screw.
The circular guide (optional accessory) can be installed
on the vacuum cover.
1
2
3
4
5
014859
Connect the hose of a vacuum cleaner/dust collector to
the vacuum cover. When connecting to Makita vacuum
cleaner, use an optional hose 28 mm (1-1/8") in inner
diameter.
1
2
3
4
014860
When connecting to Makita dust collector, connect the
hose for the dust collector directly to the dust nozzle.
MAINTENANCE
CAUTION:
•
Always be sure that the tool is switched off and the
battery cartridge is removed before attempting to
perform inspection or maintenance.
•
Never use gasoline, benzine, thinner, alcohol or
the like. Discoloration, deformation or cracks may
result.
Replacing carbon brushes
1
001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
1
2
014868
Insert the top end of slotted bit screwdriver into the
notch in the tool and remove the holder cap cover by
lifting it up.
1. Holder cap
cover
2. Screwdriver
1. Limit mark
1. Tool
2. Vacuum cover
3. Hose 28
4. Dust collector
1. Tool
2. Vacuum cover
3. Hose 28
4. Hose for
vacuum cleaner
5. Vacuum cleaner
1. Thumb screw
2. Vacuum cover
1. Knob
Summary of Contents for XSF03
Page 67: ...11 ...
