Makita XSJ05, Instruction Manual

8 ENGLISH

Hook

CAUTION:

Never hook the tool at high loca-

tion or on potentially unstable surface.

1

1

2

2

3

3

►    

1.

 Groove 

2.

 Hook 

3.

 Screw

The hook is convenient for temporarily hanging the tool. 

This can be installed on either side of the tool.

To install the hook, insert it into a groove in the tool 

housing on either side and then secure it with a screw. 

To remove, loosen the screw and then take it out.

Blade rotation

The edges of the side blades can be used in four ways 

by rotating the side blades as shown in the figure.

The time and procedure to rotate the side blades is as 

follows:
• 

When inside edges of each side blades become 

rounded to about half the width, swap each side 

blades.

• 

When both edge of each side blades become 

rounded, turn each side blades inside out.

OPERATION

Lubrication

NOTICE:

Use the standard machine oil for steel 

or the mineral spirits for aluminum.

Before operation, always lubricate the following areas:

A 

The both sides of the center blade which contacts 

to the side blade L and side blade R.

A

Adjusting cutting head angle

CAUTION:

Make sure the cutting head is 

secured in the position after adjusting the cutting 

head angle. 

Otherwise the cutting head may rotate 

during operation and cause serious injury.

Rotate the cutting head while pushing the rotation 

button.

Release the rotation button when the cutting head is in 

the desired angle.

1

►    

1.

 Rotation button