14 ENGLISH
1
►
1.
Release button
CAUTION:
After changing the bevel angle,
always secure the saw head by turning the lever
upward firmly.
NOTICE:
When tilting the saw blade, be sure the
handle is fully raised.
NOTICE:
When changing bevel angles, be
sure to position the kerf boards appropriately
as explained in the "Positioning kerf boards"
section.
Setting 46° bevel angle
1.
Loosen the lever and tilt the blade to the left or
right fully.
1
►
1.
Lever
2.
To tilt the blade to the left, hold the handle and tilt
the saw head to the right slightly, and then move the
release lever to the direction of the arrow. The bevel
angle can be adjusted between 45° to 46° by tilting the
saw head while moving the release lever.
To tilt the blade to the right, hold the handle and tilt the
saw head to the left slightly, and then move the release
lever to the direction of the arrow. The bevel angle can
be adjusted between 45° to 46° by tilting the saw head
while moving the release lever.
1 2
►
1.
Lever
2.
Release lever
3.
Turn the lever upward firmly to secure the saw
head.
Adjusting the lever position
If the lever does not provide full tightening in course of
time, change the position of the lever. The lever can be
repositioned at every 30° angle.
Loosen and remove the screw that secures the lever.
Remove the lever and install it again so that it points
slightly above the horizontal. Then, tighten the lever
with the screw firmly.
1
2
►
1.
Lever
2.
Screw
