Makita XTW01, Instruction Manual

6 ENGLISH

When you pull the eject lever, the bolt tip is ejected from 

the tool.

1

►    

1.

 Eject lever

Battery power lamp

When the remaining battery capacity becomes low, 

the battery power lamp blinks. Charge the battery or 

replace the battery with fully charged one. When the 

remaining battery capacity becomes much lower, the 

tool stops and the battery power lamp lights up.

1

►    

1.

 Battery power lamp

Hook

CAUTION:

Be sure to attach the shoulder belt 

included in the tool as the standard accessory. 

Use the shoulder belt for carrying the tool, and 

never use the hook for other purposes such as 

the fall prevention at high location.

 If the hook is 

used for other purposes, excessive load may break 

them and cause serious injury to the operator and 

person around/underneath the operator.

CAUTION:

When you attach the shoulder belt to 

the hook, be sure to attach it securely.

 If it is attached 

incompletely, the tool may come off and cause an injury.

CAUTION:

When carrying the tool using the 

shoulder belt, be careful not to entangle the shoulder 

belt with your body or objects and not to hit objects 

with the tool.

 Failure to do so may cause an accident.

CAUTION:

Remove the shoulder belt from 

the hook before operating the tool.

 Failure to do 

so may lose your balance at operation and cause an 

accident.

1

2

►    

1.

 Hook 

2.

 Shoulder belt

Attach the shoulder belt included in the tool as the 

standard accessory to the hook for carrying the tool. 

Remove the shoulder belt from the hook before operat-

ing the tool.

Electric brake

This tool is equipped with an electric brake. If the tool 

consistently fails to quickly stop after the switch trigger 

is released, have the tool serviced at a Makita service 

center.

ASSEMBLY

CAUTION:

Always be sure that the tool is 

switched off and the battery cartridge is removed 

before carrying out any work on the tool.

Removing the outer and inner 

sleeves

CAUTION:

Be careful not to allow foreign mat-

ter to enter the insides of the tool when removing 

or installing the outer and inner sleeves.

1.

Loosen the two screws while holding the outer 

sleeve. The outer and inner sleeves will be pushed up 

by the springs built into the tool.

1

2

►    

1.

 Outer sleeve 

2.

 Screw