7 ENGLISH
Lock-off
Standby
ON
To start the tool:
Press the lock switch to turn the tool into standby mode.
It turns the lamp on, too.
Press the ON/standby switch to start the tool in standby
mode.
To stop the tool:
Press the ON/standby switch to stop and turn the tool
into standby mode.
Press the lock switch to stop and turn the tool into lock-
off mode.
In standby mode, press the lock switch to turn the lamp
off and turn the tool into lock-off mode.
NOTE:
•
When the tool is in standby mode, the lamp
keeps lighting.
•
If the tool is left 10 seconds without any opera
-
tions in standby mode, the tool is automatically
turned into lock-off mode and the lamp goes off.
Lighting up the lamps
CAUTION:
•
Do not look in the lamp or see the source of
lamp directly.
To turn on the lamp, press the lock switch.
Another press of the lock switch stops the tool and the
light goes off.
NOTE:
•
Use a dry cloth to wipe the dirt off the lens of
lamp. Be careful not to scratch the lens of lamp,
or it may lower the illumination.
•
When the tool is overheated, the lamp flickers.
Cool down the tool fully before operating again.
Speed adjusting dial
1
►
1.
Speed adjusting dial
The tool speed can be infinitely adjusted by turning the
speed adjusting dial. You can get the highest speed at 6
and the lowest speed at 1.
Refer to the table to select the proper speed for the
workpiece to be cut. However, the appropriate speed
may differ with the type or thickness of the workpiece. In
general, higher speeds will allow you to cut workpieces
faster but the service life of the blade will be reduced.
Number on adjusting dial
4 - 6
Mild steel
3 - 6
Stainless steel
3 - 4
Aluminum
3 - 6
Plastics
1 - 4
Workpiece to be cut
Wood
CAUTION:
•
The speed adjusting dial can be turned only as
far as 6 and back to 1. Do not force it past 6 or
1, or the speed adjusting function may no longer
work.
NOTE:
•
When the speed adjusting dial is at 3 or higher,
the tool automatically reduces the no-load
speed to reduce the vibration under no-load.
Once the tool gets load, the tool speed reaches
the preset speed. Then the tool keeps the speed
until the tool is switched off. When temperature
is low and there is less fluidity in grease, the tool
may not have this function even with the motor
rotating.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
