Wait until the Sander has come to a complete stop before placing it down on a bench or other surface.
Sanding Surfaces:
Turn the Detail Sander on, place it with the full pad area on the surface to be sanded, and move it with
moderate pressure over the surface.
The amount of material removed is determined by the grade of the sand paper chosen, sanding rate
and the pressure applied. For best results, and to extend the life of the Detail Sander, always use
brand new sand paper.
Applying increased pressure to the Detail Sander does not lead to an increase in the sanding rate, but
instead increases the wear on the sand paper.
Only use the original accessories included in this Detail Sander.
Rough Sanding:
Attach coarse grade sand paper. Apply only light pressure to the Detail Sander so that it runs at a
higher sanding rate, achieving a high rate of removal.
Fine Sanding:
Attach fine grade sand paper. Vary the amount of pressure applied to the Detail Sander to achieve
the best results.
Maintenance and Cleaning:
Before any work commences on the Detail Sander, ensure that it is unplugged from the power outlet.
For optimum use, regularly check to see if any dust or foreign matter has entered the ventilations slots
near the motor and around the on/off switch. Use a soft brush if required. Wear safety glasses to
protect your eyes whilst cleaning.
If the body of the tool needs cleaning, wipe it with a soft damp cloth. A mild detergent can be used,
but not alcohol-based, petrol, or other cleaning agents.
Never use caustic agents to clean plastic parts.
Lubricate all moving parts at regular intervals.
CAUTION
Water must never come into contact with this tool.
DISPOSAL
Do not dispose of electrical appliances with your domestic waste!
The packaging
comprises exclusively environmentally- friendly material. Dispose of it in your local recycling
containers.
TECHNICAL DATA
DETAIL SANDER
SROM1187
Voltage rating
AC 230-240V,50Hz
Power rating
130W
No-load speed
n
o
13000min
-1
