Page
13
of
36
ATTENTION
If the controller is set in heating mode, the hysteresis operation has the opposite character,
i.e. the heating system is switched off after the temperature has dropped below the set value,
taking into account the value of the programmed hysteresis.
4.2. Control of the stirrer motoreducer.
The operation status of the stirrer is indicated by a red diode (see section 3.).
The controller has two modes of stirrer operation (automatic or manual), which are described in
detail below.
4.2.1. Automatic operation of the stirrer.
In this mode, depending on the settings of parameters F0, E1 and E2, the stirrer may be connected
to the operation of the chiller or completely independent of it (see section 3.4).
The stirrer operation setting in the automatic mode is signaled by a continuous lighting of the stirrer
operation red diode.
4.2.2. Manually triggered operation of the stirrer.
The manual stirrer operation can be initiated by pressing the button marked with the symbol
(seesection 3.); at this point, the automatic stirrer operation is stopped and the manual operation is
switched over. Manual mode is signaled by a blinking of th stirrer operation red diode.
Manual operation of the stirrer is possible when the controller is turned off, as well as when
the washing process is switched on – depending on the washing program set up and the
configuration made.
The stirrer operation in this mode can be interrupted at any time by pressing the button again.
The manual stirrer operation can take place in two variants, depending on the CP parameter settings:
setting the value 0 means continuous operation of the stirrer,
setting the value >0 means that the stirrer operates for the set number of minutes;
after the set time elapses, the manual operation of the agitator is automatically switched
off.
