22
Using the SCAN Button:
This button is used to analyze the target in case the “VALUABLE” LED is
on during you explore. The target that caused the “VALUABLE” LED to
turn on is re scanned while pressing the “SCAN” button. If the
“VALUABLE” LED is still on it could be said that your target is a precious
metal, if the “VALUABLE” LED is off it would mean that your target is not
a precious metal, but a steel sort of metal.
Adjusting the Sensitivity Setting:
After the device is turned on “SENSITIVITY”
button is pressed and sensitivity mode is
selected. The operator is informed about the
existing sensitivity level of the device by
LEDs that indicate the sensitivity level. The
operator may adjust the sensitivity level to
the desired degree by using “+” and “-“ keys.
Sensitivity consists of 4 steps:
100:
It is the level of sensitivity where the device depth is maximum.
When the device is used in this level, even smaller metal pieces are
identified in deeper ground easily. Since this step enhances the
sensitivity and power of the device it will be more affected from the
ground and operation will get harder. For this reason the ground setting
should be done as correctly as possible. When adjustment is made from
other sensitivity levels to step 100, the ground setting should be done
once again.
90:
This level has a high perception level. It is preferred in types of
ground where step “100” is not used. It has a lower perception depth
than step “100” but it affects less from ground composition than step
“100”.
Ground setting should be made once again when switching to
this level from levels “80”,”70”.
80:
This level is used in grounds with dense minerals and having
variable composition. Weak perception of small metal pieces.
Ground
setting should be made once again when switching to this level
from level ”70”. Should be used for detection of large metals or
large voids.
70:
This is the least sensitivity level. In this level the device will be less
affected from the ground. Ground adjustment can be easily made but
small metal pieces are difficult to detect.
Should be used for detection
of large metals or large voids.
Summary of Contents for JEOHUNTER 3D Dual System
