36
Coil and System Error Warnings:
If there is an error in the detector head or in the system “SERCHING
HEAD FAULT” or “SYSTEM FAULT” warning lights blink at the bottom of
the screen and a sound alarm is heard to warn the operator after the
device is switched on. In this case the operator should switch off the
device, check the connectors and witch on the device again. If the
warning persists authorized service should be called.
Checking Battery Charge Level:
The device switches to “Ground
Adjustment” section after it
detects the detector head. At
the bottom of this section there is an area that indicates battery status
and the operator detects battery status by referring to this area. When
battery charge decreases device settings change and may cause some
errors. Make sure not to use the device and charge the batteries when a
single bar is full. If the battery is depleted or does not have adequate
charge switch off the device and charge the batteries installing the
charger.
Summary of Contents for JEOHUNTER 3D Dual System
