40
HOW IS GROUND SETTING DONE?
When the device is switched on it starts with the GROUND ADJUST”
mode. Ground adjustment should be done before using the device for
correct results. During exploration when soil composition has changed
and when ground adjustment has to be done again switch to ground
mode by pressing the “GROUND” button and re-adjust ground settings
after checking existing settings.
Ground Setting Phases
1.
When the device is switched on in “LCD” mode,
ground adjustment is displayed automatically.
2.
Lift the detector head 40 cm above ground and
press the “RESET” button.
3.
When in ground mode the effect of ground on
the device is displayed on the monitor as “Ground Effect”. This effect
will change when ground adjustment is made.
4.
Make sure that there are no metals or voids in the ground where
ground setting will be made. If ground setting could not be adjusted
it will be repeated in a neighboring area.
Summary of Contents for JEOHUNTER 3D Dual System
