MAKSIWA CBC.EC, Instruction Manual

6

ADJUSTMENTS

The following shown adjustments must be made 

before  using  your  Edgebander  CBC.E  for  the  first 

time or when some kind of change is made as thick 

tape or thickness of the wood.

CAUTION:

 ANY ADJUSTMENT NEEDS TO BE MADE 

WITH THE MACHINE OFF AND DE-ENERGIZED 

(unplugged).

1. GLUE

The glue to be used in your Edgebander CBC.E 

MAKSIWA is granulated glue type Hot Melt.

Always check the amount of glue on your machine.

Because of factory tests, their CBC.E can go with a 

certain amount of glue.

If necessary insert adequate glue to the color of panel 

wood and tape that you are using.

Do not put too much glue, because when it melt and 

during  operation  of  the  machine  may  overflow  and 

cause leaks. Let also not miss glue in the glue pot 

because this can cause failures in the collage.

WARNING:

 TURN THE MACHINE IN 110V SINGLE 

PHASE.

If will need a extension Cord, utilize a cable with 3 

wires with 1,5mm² (or more).

ADJUSTMENTS

NOTE:

 The brand and quality of the glue is 

fundamental. The MAKSIWA recommends glues that 

work in the range of 160°C to 190°C. On top of that, 

high temperature and melt glues can damage the 

tape.

GLUE EXCHANGE:

 If you change the color of your tape 

or the color of the wood panel, you may change the 

glue on your Edgebander. To change the glue follow 

these steps, but first read the rest of this manual to be 

familiar with all operations:

- Turn on the machine and set the temperature 

controller to 70°C (158°F) (see this manual to program 

the controller).

-  At  this  temperature,  the  glue  is  not  too  hot  (soft) 

or too cold (hard). So you can remove the entire glue 

without much difficulty.

- Use a trowel or piece of wood, avoiding scrape the 

walls of collared, damaging the same.

- After removing all the glue, put the new glue.

- Set the temperature controller according to the 

specification of the glue again.

GLUE INDICATIONS: 

With this machine we 

recommend the following glue brands:

• Artecola - 160ºC a 180ºC - Ivory-Color. Cod. 1820  

White. Cod. 1821

• Durante Duditerm - 160ºC a 180ºC - White. Cod. 

715/15 

• Jowat - 150ºC a 180ºC - Ivory-Color. Cod. 282.20 

White. Cod. 282.21

• Proadec - 160ºC a 180ºC - Ivory-Color. Cod. 5707 

• Kleiberit - 150ºC a 180ºC - Ivory-Color. Cod. 788.3/20 

White. Cod. 788.3/10

2. TAPE (EDGEBAND)

The Edgebander CBC.E MAKSIWA is designed to work 

with PVC tape, ABS, paper and wood that do not have 

glue, only straight parts. Use tapes approximately 

4mm wider than the wood panel.

It is necessary to regulate the Edgebander according 

to the thickness of the tape. That is, when changing 

the thickness of the tape, it is necessary to adjust the 

machine again. For this setting, follow these steps:

- Cut a piece of tape to be used.

- Loosen (without removing) the two screws shown in 

the following figure, using a wrench 13: