4
UNPACKING AND ASSEMBLY
UNPACKING
Due to modern mass production techniques, it is unlikely
that Edge Trimmer RBB.1000 MAKSIWA is faulty or
have parts missing. If you find anything wrong, do not
use the machine until the parts are replaced or the fault
is corrected. Doing this you are avoiding serious injury.
1. You will receive your machine packed.
2. Remove the machine from the packed with all the
parts and accessories that go with it. For ease
assembly, place it on a bench. Note the pieces that
came with your equipment:
1. Clamps 8. Hex Hey 10/13
2. Adjustable Guide 9. Collet ¼
3. Knobs
10. Hex Key 17
4. Swinging Support
11. Cutter
5. Bolt M6x16
12. Hex Key 10
6. Piston 13. Trimmer / Router
7. Phillips Key
ASSEMBLY
1. Prepare two pieces approximately with 35x15x135mm
(1 3/8’’x 5/8’’ x 5 3/8’’) to serve as a spacer between the
setting surface and the base of the equipment:
2. Choose a table or a bench for installation. Defining its
position, considering that the two clamps (1) allows its
fixing in any point of the center of the base or outer ends
of the equipment. Note the figures below that you can
also perform this setting by the side of the tables and / or
benches:
