Maktec MT910, Instruction Manual

6

OPERATION

Turn the tool on without the wheel point making any contact with the workpiece
and wait until the wheel point attains full speed. Then apply the wheel point to
the workpiece gently. To obtain a good finish, move the tool in the leftward
direction slowly.

CAUTION:

•

Apply light pressure on the tool. Excessive pressure on the tool will only
cause a poor finish and overloading of the motor.

MAINTENANCE

CAUTION:

•

Always be sure that the tool is switched off and unplugged before
attempting to perform inspection or maintenance.

Replacement of carbon brushes

Remove and check the carbon brushes regularly. Replace when they wear
down to the limit mark. Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the same time. Use only
identical carbon brushes.

Use a screwdriver to remove the brush holder caps. Take out the worn carbon
brushes, insert the new ones and secure the brush holder caps.

To maintain product safety and reliability, repairs, maintenance or adjustment
should be carried out by an Makita Authorized Service Center.

007134

1. Limit mark

1

001145

1. Brush holder cap

2. Screwdriver

1

2

007135