www.
makute
.com
-3-
-4-
Switch action
CAUTION:
•
Before plugging in the tool, always
check to see that the switch trigger
actuates properly and returns to the
“OFF” position when released.
To start the tool, simply pull the switch
trigger. Release the switch trigger to stop.
For continuous operation, pull the switch
trigger and then push in the lock button.
To stop the tool from the locked position,
pull the switch trigger fully, and then
release it.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched
off and unplugged before carrying out
any work with the tool.
The side grip swings around to either
side, allowing easy handing of the tool
in any position. Loosen the side grip by
turning it counterclockwise, swing it to
the desired position and then tighten it by
turning clockwise.
Pull the change ring down all the way
and insert the bit into the tool holder as far
as it will go. Release the change ring and
it will return automatically to its original
position to secure the bit. After installing,
always make sure that the bit is securely
held in place by trying to pull it out. To
remove that bit, pull the change ring down
all the way and pull the bit out.
OPERATION
Chipping/Scaling/Demolition
Hold the tool firmly with both hands.
Turn the tool on and apply slight pressure
on the tool so that the tool will not bounce
around, uncontrolled. Pressing very hard
on the tool will not increase the efficiency.
MAINTENANCE
CAUTION:
•
Always be sure that the tool is switched
off and unplugged before attempting to
perform inspections or maintenance.
•
Never use gasoline, benzene, thinner,
alcohol or something like these.
Discoloration, deformation or cracks
may result in.
Summary of Contents for DH35
Page 1: ...DH35 DEMOLITION HAMMER...
Page 8: ......
