www.malags.com
11
Note!
If you select a velocity value outside selected materials range, the
material will be set t
o “User-Defined”
The option
Acquisition mode
(in the General Setting view) and
Wheel
is
changed depending on how the measurements are to be gathered; by time
or by distance. If distance is chosen the correct encoder is selected. The
standard MALÅ Geoscience wheels are found in the list.
Point interval
(or time in seconds) gives the distance between the
measured traces in the radargram.
Note!
For 3D and Object-Mapper projects only the wheel acquisition mode
is available. Point interval is fixed in 3D projects depending on the used
antenna.
For all project types (2D, 3D and Object-Mapper) the filename is given
automatically by the CX system. See also Chapter 8 File Manager.
Note!
To turn off the unit once the work is completed, use the QUIT-button
and
then
the on/off switch on the unit. If the unit is switched off using only
on/off switch, the file system in the unit can be corrupted and all the data
lost.
After using the QUIT option in the program and the power has been turned
off by the software, the user need to power off the CX unit by pressing the
ON/OFF switch on the unit itself. To turn the unit on again, wait for 5-10
seconds before pressing the ON/OFF switch.
