www.malags.com
4
1.1 Unpacking and Inspection
Great care should be taken when unpacking the equipment. Be sure to
check the contents against those shown on the packing list and inspect the
equipment for any loose parts or other damage. All packing material should
be preserved in the event of damage occurring during shipping. Any claims
for shipping damage should be filed with the carrier. Any claims for missing
equipment or parts should be filed with MALÅ Geoscience.
1.2 Repacking and Shipping
If the original packing materials are not available, the equipment should be
packed in at least 80 mm of absorbing material. Do not use shredded
fibers, paper wood, or wool, as these materials tend to get compacted
during shipping, thus permitting the instruments to move around inside the
package.
1.3 MALÅ Geoscience Indemnity Clause
Operators of MALÅ CX or other MALÅ GPR systems shall hold harmless,
defend, and indemnify MALÅ Geoscience from and against any and all
losses, liabilities, damages, injuries, claims, demands, costs and expenses
or claims including claims by third parties arising out of the use or
possession of the MALÅ GPR system.
1.4 Important information regarding the use of this
MALÅ GPR unit
According to the regulations stated in ETSI EN 302 066-1 (European
Telecommunication Standards Institute):
-
The CX unit should not be left ON when leaving the system
unintended. It should always be turned OFF when not in use.
-
The antennas should point towards the ground, walls etc. during
measurement and not towards the air.
-
The antennas should be kept in close proximity to the media under
investigation.
See also Chapter 9 System Settings.
