4/10
©
PHANTOS
®
Distributed in Australia by PHANTOS www.phantos.com.au
2.2.1 Line Termination
In DMX Mode, at the last fixture in the chain, the DMX output has to
be connected with a DMX terminator. This prevents electrical noise
from disturbing and corrupting the DMX control signals. The DMX
terminator is simply an XLR connector with a 120
(ohm) resistor
connected across pins 2 and 3, which is then plugged into the
output socket on the last projector in the chain. The connections are
illustrated below.
2.3 AC Power
This product has an auto-ranging power supply that can work with
an input voltage range of 100~240 VAC, 50/60 Hz.
Warning!!! All fixtures must be connected to circuits
with a suitable Earth Ground.
5/10
©
PHANTOS
®
Distributed in Australia by PHANTOS www.phantos.com.au
3 OPERATION INSTRUCTIONS
Fill the Blizzard 600 with MLB snow liquid or other dealer recommended
liquid to the maximum level mark shown on its tank. The machine can
be controlled through a wireless controller only.
A fan speed switch at the back of the machine sets two different fan
speed level (Min, or Max).
Important: Always monitor tank fluid level during operation. Running a
snow machine with no fluid can permanently damage the unit.
3.1 Wireless Remote
Attach the receiver’s magnetic base to the machine. Plug the
receiver’s cable into the machine’s remote control input. Using the
sending unit, your Blizzard 600 can be operated from a distance of up to
50 meters. Start emission by pressing the Unlock button on the sending
unit. Stop emission by pressing the Lock button. Multiple Blizzard 600 may
be controlled using only one sending unit.
