INSTALLATION OF THE LIGHT, OPERATION INSTRUCTIONS
Please pay attention to place your light in a
non-shaded place with sufficient sunshine
provided for its operation.
Installation of the light:
1.
If you prefer to fix your light in soil,
please follow the instructions below:
a)
Remove the nut and the washer from the pin. If you
cannot loosen the nut by hand, please apply an allen key.
b)
Place the light on the pin’s threaded end. The small hole
in the middle of the light’s stand is made for fixing the pin.
c)
Place the washer on the threaded end from the top,
then drive the nut by hand. Tighten the nut with an allen
key.
d)
Push the light gently in the soil at the preferred location
until the stand reaches the surface of the soil. Make sure
the light is vertical from all viewpoints after fixing.
2.
If you prefer to fix your light on a hard surface, follow the instructions
below:
a)
Please care that the horizontal surface you are about to fix your light
on should be levelled correctly. It is recommended to position the light
on its final place, then mark the 2 locations of the holes.
b)
After marking the locations of the holes, remove the light, and drill
the holes.
c)
Push the 2 screws together with the hit-in dowels on
them inside the holes with a hammer.
d)
Remove the nuts and the washers from the screws.
e)
Place the light on its final position on the screws.
f)
Place the washers then the nuts on the screws, drive
the nuts by hand until you can, then tighten them with
a wrench.
5
Summary of Contents for ONYX TWIN WARM WHITE
Page 2: ...2 ...
