PRODUCT INSTALLATION AND OPERATION INSTRUCTIONS
Please pay attention to place your light in a non-shaded place with
sufficient sunshine provided for its operation.
Installation of the light:
4 holes are located on the stand of the column
below for fixing the light on a horizontal surface.
The distances of the fixing holes are shown here:
1. Please care that the horizontal surface you are about
to fix your light on should be levelled correctly. It is
recommended to position the light on its final place, then
mark the 4 locations of the holes.
2. After marking the locations of the holes, remove the light,
and drill the holes.
3. Push the anchors inside the holes.
4. Place the light on its final position, and drive in the screws
with a screwdriver.
5. Remove the Silicone plug from the upper part of the
column, and pay attention not to lose the item further on.
Place the allen key in the hole like shown above, and gently
press the hidden ON/OFF button shortly one time. The
light turns on (in daylight conditions the light sensor turns
off the light, which will turn on again at dusk).
6. Place the Silicone plug on the hole correctly.
5
Summary of Contents for ZEPHYR 90 GREY
Page 2: ...2 ...
