04.A
13-05-03
Step 3
Removing and/or replacing the programmer (B290) from the
control panel (B270):
(a)
Remove the top cover (
Step 1
).
(b)
Remove the programmer knob by grasping it gently and
pulling (
Step 2
).
(c)
Use a crosshead screwdriver to remove the two screws (
B250
)
fixing the programmer (
B290
) to the control panel (
B270
).
(d)
To remove the electrical connections from the programmer,
proceed as follows:
- Use a flat screwdriver as a lever on the connector clip and remove
the connector.
- Use the pliers to remove the other electric wires,
noting their positions.
(e)
To re-assemble, follow the same procedure in reverse order, taking
care to check that the wire colours and markings correspond to
the appliances wiring diagram.
S
tep 4
Removing and/or replacing the buttons (B210) and switches (B330-B340) from the control panel:
(a)
Remove the top cover (
Step 1
).
(b)
To remove the buttons (
B210
), insert the point of a screwdriver in the button mounting slot on the
inside of the control panel and then push the button outwards.
(c)
To remove the switches (
B330-B340
) from the front of the control panel, use a screwdriver
as a lever on the retaining lugs and then remove the switches.
(d)
Disconnect the wiring noting the positions of the wires.
(e)
To re-assemble, follow the same procedure in reverse order.
MAINTENANCE PROCEDURES
B067
B250
B290
B270
B210
B340 B330
Retaining lugs
