10.A
13-05-03
For driers produced prior to week 18 of 2003
B430
B450
Step 16A
Removing and/or replacing the rear panel (B580):
(a)
Remove the top cover (
Step 1
).
(b)
Remove the power supply cable.
(c)
From the back of the drier, use a crosshead screwdriver to remove
the lower fixing screw securing the rear panel (
B580
).
(d)
Remove the four fixing screws (
A470
) securing the drum shaft
support cover (
B650
), and then remove the drum
shaft support (
B640
).
(e)
Remove the eight fixing screws (
A460
) securing the rear panel, then
remove the panel (
B580
).
NB:
When replacing the rear panel (
B580
), recover all the components
fixed to it (see exploded view):
A460 Body Fixing Screw
A470 Support cover fixing screw
A500 Thermostat
Plate fixing screw
A520 Air Intake Cover Fixing Screw
A540 Earth Plate fixing screw
B006 Manual Reset Safety Thermostat
B020 Thermostat plate
B025 Rear Drum Gasket
B030 Maximum Temperature Thermostat
B051 Air Intake Inspection Cover + Welded Protection
B300 Suppressor Coil
B450 Terminal Block
B530 Heater Element Mounting Cover Fixing Screw
B540 Air Intake Inspection Cover
B550 Heater Element Mounting Cover
B560 Heater Element
B640 Drum Shaft Support
B650 Drum Shaft Support Flange
B670 Inspection Cover Protection
(f)
To assemble, follow the same procedure in reverse order,
remembering to temporarily insert the drive belt (
A290
) around
the drum (
A300
) (
Step 18
).
Then reconnect the motor terminal block and heater element wiring.
When replacing the drum shaft support only (
B640
), apply the grease
supplied as spare part number
190013800
on the inside part
in contact with the drum shaft.
Make sure that the teeth of the drum shaft
support are facing the rear panel.
MAINTENANCE PROCEDURES
B550
A490
A520
A470
B650
B530
A540
B560
A460
}
B670 B540
B051
B022
B580
A500
B020
B470
B300
B030
B025
B006
