13.A
13-05-03
Step 19
Removing and/or replacing the drum assembly (A300):
(a)
Remove the top cover (
B360
) as described in
Step 1
.
(b)
Remove the rear panel (
B580
) following
Step 16
, dismantling only those parts necessary.
(c)
Manually remove the belt (
A290
) from the drum and motor.
(d)
Remove the two fixing screws (
A510
) securing the tie rods (
B350
) to the back of the drier.
Push the side panels apart and extract the drum.
T
To re-assemble, follow the same procedure in reverse order, following
Step 18
to replace the belt.
Step 21
Replacing and/or removing the slide blocks (A530) and the felt seal (A410) from
the drum support surround (A340):
(a)
Remove the top cover (
B360
) as described in
Step 1
.
(b)
Remove the rear panel (
B580
) following
Step 16
, dismantling only those parts necessary.
(c)
Manually remove the belt (
A290
) from the drum and motor.
(d)
Remove the two fixing screws (
A510
) securing the tie rods (
B350
) to the back of the drier.
Push the side panels apart and extract the drum.
(e)
Press on the rear lug of the slide block (
A530
) with one hand and remove the block.
At this point the felt seal (
A410
) can be removed using a screwdriver.
NB:
When replacing either the slide blocks or the felt seal, it is advisable to fit both new slide blocks
(
A530
) and a new seal (
A410
). A kit is available for this operation and can be ordered as spare
part number
720208100
. The kit also contains the two-sided adhesive tape for fixing the felt seal.
(f)
To re-assemble, follow the same procedure in reverse order, following
Step 18
to replace the belt.
Step 20
Replacing and/or removing the drum paddle with probe (A320) and/or the drum paddle
without probe (A310) from the drum assembly (A300):
(a)
Remove the top cover (
B360
) as described in
Step 1
.
(b)
Remove the three fixing screws (
A420
) securing the paddle
to be replaced.
(c)
To re-assemble, follow the same procedure in reverse order,
following
Step 18
to replace the belt.
MAINTENANCE PROCEDURES
A420
A310
A320
