should be changed at three or six months according to your cooking habit. The
installation procedure of activated carbon filter is as below.
1.Before installing or replacing the carbon filters,
please remove power to the unit.
2.Press the filter lock and remove the mesh filter.
3.Turn the carbon filter on both side of the motor
anti-clockwise. Replace the carbon filters with the
new carbon filters.
4.Place the mesh filter.
5.Connect the power supply to the wall socket.
NOTE:
•
Make sure the filter is securely locked. Otherwise, it would loosen and cause
dangerous.
•
When activated carbon filter attached, the suction power will be lowered.
BULB REPLACEMENT
Important :
The bulb must be replaced by the manufacturer, its
service agent or similarly qualified persons.
Always switch off the electricity supply before
carrying out any operations on the appliance. When
handling bulb, make sure it is completely cooldown
before any direct contact to hands.
When handling globes hold with a cloth or gloves
toensure perspiration does not come in contact with
theglobe as this can reduce the life of the globe.
LED LIGHTS:
1. Switch the unit off and pull out the plug first.
2. Wait until the light bulb is cooled down before replacement.
3. Open the inner glass,take down the aluminiumfilter,loose the buckle screw with
screwdriver and take down the hood body,then use screwdriver to take away the
screw connecting the panel and cabinet,unpin the lamp wire and switch wire,remove
the panel assembly,then use screwdriver to take away the screw of lamp bracket and
push the light out from the lamp bracket.
4. Replace with same type of bulb (LED 1.5W Max)
Note
：
Light replacement should carried out by qualified service personnel only.
– Max wattage: 2x1.5W
– LED modules –rectangle LED lamp
– Voltage range: DC 12V
– Dimensions:
10
