11
EN
• For DIN rail installation.
• Digital electronic general purpose time switch with week and pulse programme.
• Repeat programmes with 16 on/off time settings, 18 pulse programme intervals and
manual on/off setting.
• Lithium battery power reserve when electric supply cut off.
• Auto time error correction ±30 sec, weekly.
BASIC SETTINGS
Before programming for the first time, please press the ”RESET” key.
12 or 24 Hour Mode
The timer is set to 24 hr mode. If you would like to change to 12 hr mode, press and hold the
” ” key for 5 seconds and the LCD will display ”AM”. If you would like to return to 24 hr
mode, press and hold the ” ” key again for 5 seconds.
Setting the Week Day and Time
1. Press and hold the ” ” key while pressing ”D+” repeatedly, to go to correct day.
2. Press and hold the ” ” key while pressing ”H+/M+” to change the hr/min.
PROGRAMMING
The programming will quit automatically after 10 seconds of inactivity.
Day/Week Programme
Step Key
Programming
1
Press ”P”
Set the first ON time (the display shows ”1 on” and ”--:--”).
2
Press ”H+/M+”
Set hours and minutes.
3*
Press ”D+”
Select week programme (see table below).
4
Press ”P”
Set the first OFF time (the display shows ”1 off” and ”--:--”).
5
Press ”H+/M+”
Set hours and minutes.
6*
Press ”D+”
Select week programme (see table below).
7
Press ”P”
To save.
8**
Repeat step 2-7
To set the rest of the ON/OFF times (up to 16 ON/OFF).
9
Press ” ”
To end the programming.
*
If you would like to have the same time every day you do not need to press this key.
** If you do not need 16 different time settings, press ” ” to end.
Summary of Contents for 13 396 02
Page 15: ...15...