18
Headset Connection
Connect the connector of supplied headset
microphone to the connecting jack of trans-
mitter (shown on the left). Set the transmitter
work state in wireless headset system.
Battery Installation
Headset and microphone battery
installation
Push open the battery cover, insert
the supplied batteries into battery
jar in polarity and cover the battery
cover.
Tips to achieve optimum performance
• Be sure you always can see one of the receiving antennas of the transmitting position.
• Keep the distance from transmitter to receiver as short as possible.
• Bring the reception antennas into an angle of 45 ° from the vertical.
• Make sure that the receiving antenna is not located near metal surfaces.
• Pay attention to the level of the batteries and replace the batteries if the red light turns on.
• If you use the receiver on a rack or a conditioning system, make sure that antennas do not touch.
• Before a demonstration or presentation make a test tour. If there are anx spots with bad reception,
change the location of the receiver. If there are still spots with bad reception, mark and dodge
them.
