3
Product
Guide
Touch RFID
Key Managed
Assigned Use Functionality
Setup
Locks are shipped with factory default settings (only operates by pressing
). Each lock must be set up to operate with a
Programming Key and Manager Keys.
1
2
3
4
Insert the Programming Key.
A two-tone beep will be heard
and the LED will flash.
While the LED is flashing, insert
one Manager Key at a time.
A two-tone beep will be heard for
each Manager Key programmed.
While the LED is flashing, insert
the Programming Key.
A two-tone beep will be heard
and the LED will turn off.
Repeat above steps for each lock
or follow instructions to Express
Register Manager Keys to setup
all locks.
Programming
Instructions
Express Register Manager Keys
The Programming Key can quickly program multiple locks to operate with the same Manager Keys.
1
2
Go to the lock already programmed to operate with the Manager Keys.
Touch and hold
for 10 seconds (a two-tone beep will be heard
after 5 seconds followed by 2 sets of two-tone beeps after 10
seconds) then release. The LED will flash.
While the LED is flashing, insert the Programming Key.
A two-tone beep will be heard and the LED will turn off.
3
4
At each lock to be programmed, insert the Programming Key.
A two-tone beep will be heard and the LED will flash once to indicate
successful registration.
To end Express Registration mode:*
Go to any programmed lock.
Press
then insert the Programming Key.
*The Programming Key will continue to function in Express Registration mode until it is used to operate a lock.
