4
Product
Guide
Touch RFID
Key Managed
Assigned Use Functionality
Programming
Instructions
Add Manager Keys
Manager Keys can be programmed to the locks at any time.
1
2
3
4
Go to a lock requiring additional
Manager Keys.
Touch and hold
for 5 seconds
(a two-tone beep will be heard after
5 seconds) then release.
The LED will flash.
While the LED is flashing, insert
the Programming Key.
A two-tone beep will be heard.
While the LED is flashing, insert
each additional Manager Key one
at a time.
A two-tone beep will be heard for
each Manager Key programmed.
Insert the Programming Key.
A two-tone beep will be heard
and the LED will turn off.
Repeat above steps for each lock
or follow instructions to Express
Register Manager Keys to quickly
program multiple locks to operate
with the same Manager Keys.
Replace Keys
The locks must be reprogrammed to prevent the lost/stolen keys from operating a lock.
1
2
To replace the Programming Key:
Note the order or serial number (found on the lock’s rear).
Contact supplier to purchase a replacement Programming Key.
1a
1b
2a
2b
To replace the Manager Keys:
Collect all remaining and replacement Manager Keys.
Go to any lock operated by the lost/stolen Manager Keys. Touch and
hold
for 5 seconds (a two-tone beep will be heard after 5
seconds) then release.
The LED will flash.
While the LED is flashing, insert the Programming Key.
A two-tone beep will be heard.
Insert the Programming Key again.
Three sets of two-tone beeps will be heard and the LED will turn off. All
previously programmed Manager Keys will be erased.
Follow instructions to Add Manager Keys to program the remaining and
replacement Manager Keys to the locks.
