27
M5 – Eco
CE
If there is insufficient pressure in the jet, examine the air nozzle
for possible obstructions and both hoses for possible bends. In
the case of obstruction the parts must be cleaned
immediately! In the same way promptly eliminate possible
bends found on the hoses!
During the vaporising procedure the difference of maximum height
between the sprayer and the machine can be
20 m
. If this distance is
exceeded bring the machine closer to the intervention zone. To do this,
observe the instructions relative to transporting the machine present in this
manual!
During the vaporising procedure check whether the flow has
been interrupted. In any case avoid the formation of possible
bends and obstructions on the hoses.
Stopping the work
It is enough to close the air tap in the case of a brief interruption of work
(less than 20 minutes).
The machine must be cleaned in the case of interruptions longer than 20
minutes. Observe the instructions in the „Ending work and cleaning”
chapter during the procedure. Interruption time is reduced to 10 minutes
using rapid binding material. In any case we recommend observing the
instructions provided by the manufacturer of the material.
Refilling dry material
The material at the outlet of the sprayer becomes increasingly watery as
the dry material is slowly used up. At this point the work must be interrupted
and the instructions in the next chapter followed. It is possible to restart the
work after filling the container with new dry material.
Choosing the dry material
The material previously used must be removed before being able to fill the
container with the new material In the case of using another type of dry
material in the container.
The machine must be stopped and the electrical power
disconnected by removing the plug from the electrical box to
do this!
It is now possible to remove the protection grill from the sprayer and
remove the dry material.
Install and fix the grill again before restarting the machine.
The pump and the hoses must also be emptied and cleaned if
changing the material used. Consult the information in the
„Ending work and cleaning“ paragraph to do this.
Attention!
The machine must be turned off, disconnecting the power by
removing the plug from the socket, before any intervention
(cleaning, maintenance, repair).
Check the machine before every use. In particular, check that
all the protective covers are integral, mounted and fixed.
It will not be possible to use the machine if damage eventually
occurs!
ATTENTION
ATTENTION
ATTENTION
ATTENTION
ATTENTION
Important
www.markham-sheffield.co.uk - Tel: +44 (0) 1909 730861