Zetasizer Nano accessories guide
Page 2-1
2
General cells
and cuvettes
Introduction
Malvern offers a range of cells and cuvettes for performing measurements with the
Zetasizer system. The choice of cell or cuvette is dependent upon the type of
measurement being performed and the sample that will be measured.
The cells or cuvettes available for each measurement type are fully documented in
this chapter with some discussion on their use and application. The aspects covered
are:
Identification of each cell of the dispersion units with guidance on selection.
How to fill each cell with sample and then insert into the Zetasizer Nano
instrument.
Some accessories require configuration of the software and SOP parameters.
Where required the software controls are identified with explanation on how to
use the cells to make measurements on the system.
Maintenance procedures for inspecting and cleaning each cell and its respective
components, including identification of the chemical compatibility of the cell
components that may come into contact with the sample.
Summary of Contents for Zetasizer Nano Series
